Front Wheel Opening Molding Replacement

WARNING: This page is about a different car, the 2020 GMC Terrain and 2020 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Front Wheel Opening Molding Retainer [18x]
2	Front Fender Wheel Opening Molding Procedure Apply two layers of masking tape around the top edge of the front wheel opening molding to prevent any paint surface damage. Using a suitable flat bladed plastic tool, release the retainers from the front fender. Pull upward to release the molding from the front bumper lower fascia. Using a 50/50 mixture of isopropyl alcohol and clean drinkable water and a clean towel, remove the left over adhesive residue from the masking tape.

Callout

Component Name

Front Wheel Opening Molding Retainer [18x]

Front Fender Wheel Opening Molding

Procedure

Apply two layers of masking tape around the top edge of the front wheel opening molding to prevent any paint surface damage.
Using a suitable flat bladed plastic tool, release the retainers from the front fender.
Pull upward to release the molding from the front bumper lower fascia.
Using a 50/50 mixture of isopropyl alcohol and clean drinkable water and a clean towel, remove the left over adhesive residue from the masking tape.