Rear Seat Removal and Installation
WARNING: This page is about a different car, the 2020 GMC Terrain and 2020 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
 Courtesy of GENERAL MOTORS COMPANY
|
| Callout |
Component Name |
Preliminary Procedure
Using a suitable tool, press the button to release the belt from the mini buckle. Rear Center Seat Belt Retractor Replacement |
| 1 |
Rear Seat Actuator Finish Cover Bolt Cap |
| 2 |
Rear Seat Bolt [11x]
Procedure
- Fold the seat back down.
- Remove the front bolts.
- Fold the seat bottom up to gain access to the rear bolts.
- Prepare the bolts for installation as follows:
- Remove all traces of the adhesive patch from the bolt and the mating threads using the appropriate tools.
- Clean the threads of the bolt and mating threads with denatured alcohol or equivalent and allow to dry.
- Apply thread locking adhesive to the bolt. Adhesives, Fluids, Lubricants, and Sealers
- Ensure there are no gaps in the thread locking adhesive once applied to the bolt.
Tighten
45 N.m (33 lb ft) |
| 3 |
Rear Seat Procedure
- Disconnect electrical connections, if applicable.
- Disconnect the recliner cable from the release lever cable equalizer. Lift the carpet flap to access, slide the retainer door open and disconnect the cable.
- Remove elastic band from the seat belt buckles.
- With the aid of an assistant remove the rear seat by lifting and pulling the seat upward to disengage it from the floor.
- Separate the rear seats. Rear Seat Separation
|