Drive Chain, Drive Sprocket, and Driven Sprocket Assemble

WARNING: This page is about a different car, the 2020 GMC Terrain and 2020 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Torque Converter Fluid Seal Ring Procedure Place DT-51191 - 4 which is part of DT-51191 Pump Seal Installer Set over the Stator Support. Place a NEW Torque Converter Fluid Seal Ring onto DT-51191 - 4 . Use DT-51191 - 2 to push the Torque Converter Fluid Seal Ring down over DT-51191 - 4 into the Seal groove. Remove DT-51191 - 4 Install DT-51191 - 1 with the chamfer end down over the Torque Converter Fluid Seal Ring and leave on the Seal Ring for at least 60 seconds. Special Tools DT-51191 Pump Seal Installer Set Equivalent regional tools: Special Tools
2	Driven Sprocket Thrust Washer
3	Drive Link Procedure Install the sprockets and chain together as an assembly..
4	Drive Sprocket
5	Driven Sprocket
6	Drive Sprocket Retaining Ring
7	Automatic Transmission Fluid Baffle
8	Automatic Transmission Fluid Pump Locating Pin [2x]