Removal Procedure
Brake Pedal Position Sensor (1) - Remove - Brake Pedal Position Sensor Replacement
Power Brake Booster Vacuum Sensor Electrical Connector (1) - Disconnect
Power Brake Booster Vacuum Sensor (1) - Remove
Master Cylinder (1) - Remove - Brake Master Cylinder Replacement
Electronic Brake Control Module with Brake Pressure Modulator Valve (1) - Remove - Electronic Brake Control Module with Brake Pressure Modulator Valve Replacement
Power Brake Booster Bolt (1) - Loosen [ 2x ]
- NOTE:
With the aid of an assistant, hold the power brake booster away from the dash panel and pull the brake pedal rearward to disconnect the brake pedal retainer from the power brake booster pushrod.
Brake Pedal (1) - Disconnect
Brake Pedal Retainer (1) - Remove and DISCARD
Power Brake Booster (1) - Remove
Power Brake Booster Seal (1) - Remove
- Power Brake Booster Seal - Inspect for damage