Manual Shift Detent Lever Shaft Replacement

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts in the following chart represent components shown in graphic above.

Callout	Component Name
Preliminary Procedures Disconnect the electronic transmission range selector manual park release cable from the automatic transmission range selector lever cable lever, then position out of the way. Electronic Transmission Range Selector Manual Park Release Cable Replacement Control Valve Body Replacement
1	Manual Shaft Detent Lever Hub Pin CAUTION: Refer to Fastener Caution . Procedure Install the manual shaft detent lever hub pin to correct height. NOTE: Install a NEW manual shaft detent lever hub pin. Specification 7.9 mm (0.38 in) (a)
2	Manual Shaft NOTE: Lubricate the shaft with ATF to prevent damage to the manual shift shaft seal during installation.

Callout

Component Name

Preliminary Procedures

Disconnect the electronic transmission range selector manual park release cable from the automatic transmission range selector lever cable lever, then position out of the way. Electronic Transmission Range Selector Manual Park Release Cable Replacement
Control Valve Body Replacement

Manual Shaft Detent Lever Hub Pin

CAUTION:

Procedure
Install the manual shaft detent lever hub pin to correct height.

NOTE:

Install a NEW manual shaft detent lever hub pin.

Specification
7.9 mm (0.38 in) (a)

Manual Shaft

NOTE:

Lubricate the shaft with ATF to prevent damage to the manual shift shaft seal during installation.