Removal Procedure

Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
Remove the electrical harness bracket nuts (1).

Courtesy of GENERAL MOTORS COMPANY
Remove the electrical harness bracket (2) from the control valve body cover and position out of the way.
Drain the transmission fluid. Transmission Fluid Drain and Fill
Disconnect the control valve body transmission control module electrical connector (1), then unclip the wiring harness from the cover.

Courtesy of GENERAL MOTORS COMPANY
Transmission Fluid Cooler Inlet Pipe (1) @ Transmission - Disconnect - Transmission Fluid Cooler Inlet and Outlet Pipe Replacement (LSY)

Courtesy of GENERAL MOTORS COMPANY
Transmission Fluid Cooler Outlet Pipe (2) @ Transmission - Disconnect - Transmission Fluid Cooler Inlet and Outlet Pipe Replacement (LSY)

Courtesy of GENERAL MOTORS COMPANY
Remove the body ground cable and wiring harness assembly mounting bolt at front of transmission and position ground cable and harness out of the way.
Remove the control valve body cover bolts (1, 2).

Fig 1: Identifying Control Valve Body Cover Bolts With Tightening Sequence
Courtesy of GENERAL MOTORS COMPANY
Remove the control valve body cover (1).

Courtesy of GENERAL MOTORS COMPANY
Clean the transmission case and control valve body cover gasket surfaces. Inspect and replace the gasket as necessary.