Installation Procedure
- Install the control valve body cover (1) and gasket.
- Hand start the control valve body cover bolts (1, 2).
NOTE:
The number (1) bolts are stud bolts.
- Install the control valve body cover bolts. Tighten the bolts in sequence to 11 N.m (97 lb in).
- Install the body ground cable and wiring harness assembly to the front of transmission.
- Transmission Fluid Cooler Outlet Pipe (2) @ Transmission - Connect - Transmission Fluid Cooler Inlet and Outlet Pipe Replacement (LSY)
- Transmission Fluid Cooler Inlet Pipe (1) @ Transmission - Connect - Transmission Fluid Cooler Inlet and Outlet Pipe Replacement (LSY)
- Connect the control valve body transmission control module electrical connector (1), then clip the wiring harness to the cover.
- Fill the transmission with correct fluid. Adhesives, Fluids, Lubricants, and Sealers
- Check transmission fluid level. Transmission Fluid Level and Condition Check
- Install the electrical harness bracket (2) to the control valve body cover.
- Install the electrical harness bracket nuts (1) and tighten the bolts to 9 N.m (80 lb in).
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Check for leaks.
CAUTION:
Refer to Fastener Caution .
NOTE:
Install all control valve body cover bolts and stud bolts by hand then torque all bolts in sequence.