Engine Rear Noise Shield Replacement

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts in the following chart represent components shown in graphic above.

Callout	Component Name
Preliminary Procedures Power Brake Booster Vacuum Hose Replacement (LGX) Loosen the heater inlet and outlet pipe bolts approximately half way. Heater Inlet And Outlet Pipe Replacement (LGX)
1	Engine Rear Noise Shield WARNING: The noise cancelling foam component MUST be replaced if it has been exposed to engine fluids. Failure to replace the noise cancelling foam component that has been exposed to engine fluids may result in an engine fire resulting in catastrophic engine damage, and possible injury or death. Procedure Unsnap the engine rear noise shield. Fill/top off the cooling system to the proper level. Cooling System Draining and Filling (Static Fill LCV, LGX) , or Cooling System Draining and Filling (GE-47716 LCV, LGX) Start the engine and check for coolant leaks.

Callout

Component Name

Preliminary Procedures

Power Brake Booster Vacuum Hose Replacement (LGX)
Loosen the heater inlet and outlet pipe bolts approximately half way. Heater Inlet And Outlet Pipe Replacement (LGX)

Engine Rear Noise Shield

WARNING:

The noise cancelling foam component MUST be replaced if it has been exposed to engine fluids. Failure to replace the noise cancelling foam component that has been exposed to engine fluids may result in an engine fire resulting in catastrophic engine damage, and possible injury or death.

Procedure

Unsnap the engine rear noise shield.
Fill/top off the cooling system to the proper level. Cooling System Draining and Filling (Static Fill LCV, LGX) , or Cooling System Draining and Filling (GE-47716 LCV, LGX)
Start the engine and check for coolant leaks.