LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2021 >> Acadia SL >> Repair and Diagnosis >> External Pages >> Different car >> Section 326 (Automatic Transmission - 9T60 (M3G) Or 9T65 (M3W) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Strut Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2023 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Lifting and Jacking the Vehicle .
  2. Prior to removing the mount, mark the mount fasteners to mount and mount to sub frame interfaces using spray paint or a marker for correct positioning during installation.
  3. Remove the two piece propeller shaft. Two-Piece Propeller Shaft Replacement .
  4. Using a suitable jack stand, support the rear of the powertrain.
  5. Disconnect the intermediate steering shaft from the steering gear. Intermediate Steering Shaft Replacement
  6. Remove the left and right side front cradle rear braces then carefully lower the drivetrain and front suspension cradle enough to remove the rear mount bolts. Front Cradle Rear Brace Replacement
  7. GM4287551Courtesy of GENERAL MOTORS COMPANY

    Remove the transmission mount to bracket through bolt (1).

    8. NOTE:

    The nuts are reusable.

  8. Remove and DISCARD the rear mount to drivetrain and front suspension cradle bolts (2).
  9. Remove the transmission rear mount.
scientia non olet · About LEMON Manuals