Removal Procedure
WARNING: This page is about a different car, the 2023 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle. Lifting and Jacking the Vehicle .
- Prior to removing the mount, mark the mount fasteners to mount and mount to sub frame interfaces using spray paint or a marker for correct positioning during installation.
- Using a suitable jack stand, support the rear of the powertrain.
Front Brake and Fuel Feed Front and Evaporative Emission Pipe Clip (1) - Remove
- Evaporative Emission Front Pipe (2) - Reposition
- Fuel Feed Pipe (3) - Reposition
Remove the transmission mount to bracket through bolt (1).
- Remove and DISCARD the rear mount to drivetrain and front suspension cradle bolts (2).
- Remove the transmission rear mount (3).
NOTE:
The nuts are reusable.