Powertrain Mount Balancing

WARNING: This page is about a different car, the 2023 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

Air Cleaner Assembly - Remove - Air Cleaner Assembly Replacement
Engine Support Fixture - Install - Engine Support Fixture
Raise the vehicle. Lifting and Jacking the Vehicle
Courtesy of GENERAL MOTORS COMPANY

Rear Transmission Mount Through Bolt (1) - Loosen
Courtesy of GENERAL MOTORS COMPANY

Front Transmission Mount Through Bolt (1) - Loosen
Lower the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Transmission Mount Bolt (1) - Loosen [4x]
Courtesy of GENERAL MOTORS COMPANY

Engine Mount Fastener (2) - Loosen [3x]
Adjust the engine support fixture in order to allow a 1/8 inch gap between the mount and bracket.
Fig 1: Identifying Transmission Mount And Bolts With Tightening Sequence
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

NOTE:
Refer to the procedure link for torque specification.

Transmission Mount Bolt (1) - Tighten in sequence [4x] - Transmission Mount Replacement
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Refer to the procedure link for torque specification.

Engine Mount Fastener (2) - Tighten [3x] - Engine Mount Replacement - Right Side
Engine Support Fixture - Remove - Engine Support Fixture
Shake the powertrain vigorously from front to rear and allow the powertrain to settle.
Raise the vehicle. Lifting and Jacking the Vehicle
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Refer to the procedure link for torque specification.

Front Transmission Mount Through Bolt (1) - Tighten - Transmission Front Mount Replacement
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Refer to the procedure link for torque specification.

Rear Transmission Mount Through Bolt (1) - Tighten - Transmission Rear Mount Replacement
Lower the vehicle.
Air Cleaner Assembly - Install - Air Cleaner Assembly Replacement