LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2021 >> Acadia SL >> Repair and Diagnosis >> External Pages >> Different car >> Section 180 (Automatic Transmission - 9T50 (M3H), 9T60 (M3G) Or 9T65 (M3W M3V) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0711-P0713 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2020 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition/Vehicle - Off
  2. Remove the component : Transmission Cover
  3. Disconnect the electrical connector : X1 @ T12 Automatic Transmission Assembly
  4. Test for 45 to 44000 ohms between the test points : Signal terminal 23 & Low Reference terminal 22
    • If not between 40 and 45000 ohms 

      Replace the component : B13 Transmission Fluid Temperature Sensor

    • Go to next step : If between 40 and 45000 ohms 
  5. Verify the value is within the range listed in the table : Refer to : Temperature Versus Resistance (B13 Transmission Fluid Temperature Sensor)
    • If not in the specified range 

      Replace the component : B13 Transmission Fluid Temperature Sensor

    • Go to next step : If in the specified range 
  6. All OK.
scientia non olet · About LEMON Manuals