LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2021 >> Acadia SL >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (Automatic Transmission - 9T50 (M3H), 9T60 (M3G) Or 9T65 (M3W M3V) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Strut Replacement (Front Wheel Drive) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2020 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Lifting and Jacking the Vehicle .
  2. Prior to removing the mount, mark the mount fasteners to mount and mount to sub frame interfaces using spray paint or a marker for correct positioning during installation.
  3. Using a suitable jack stand, support the rear of the powertrain.
  4. GM4729017Courtesy of GENERAL MOTORS COMPANY

    Remove the transmission mount to bracket through bolt (1).

    5. NOTE:

    The nuts are reusable.

  5. Remove and DISCARD the rear mount to drivetrain and front suspension cradle bolts (2).
  6. Remove the transmission rear mount (3).
scientia non olet · About LEMON Manuals