Front Cradle Rear Brace Replacement

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts in the following chart represent components shown in graphic above.

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Lifting and Jacking the Vehicle Support the front cradle with a suitable jack.
1	Drivetrain and Front Suspension Cradle Bolt [2x] CAUTION: Refer to Fastener Caution CAUTION: This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component. NOTE: Replace with a NEW bolt. Tighten First Pass: 160 N.m (118 lb ft) Final Pass: (60 - 75 degrees)
2	Front Cradle Mount Bolt Bracket Bolt [4x] Tighten 58 N.m (43 lb ft)
3	Front Cradle Rear Brace-Right Side
4	Front Cradle Rear Brace-Left Side