Circuit/System Description

The fuel level sensor changes resistance based on fuel level and is wired to the Fuel Pump Driver Control Module. The Fuel Pump Driver Control Module sends the fuel level sensor reading to the Engine Control Module (ECM) via serial data. The ECM monitors the fuel level sensor signal in order to determine the fuel level. When the fuel tank is full, the resistances of both fuel level sensors are low. When the fuel tank is empty, the resistances of the fuel level sensors are high. The ECM uses the signal voltages of the primary fuel level sensor and the secondary fuel level sensor to calculate the percentage of remaining fuel in the tank. The ECM sends the fuel level percentage via serial data to the body control module (BCM). The BCM then sends the fuel level percentage via serial data to the P16 Instrument Panel Cluster Control Module to control the fuel gauge.