Installation Procedure
- Install the electronic transmission range selector manual park release cable to the vehicle.
- Install the electronic transmission range selector manual park release cable grommet to the cowl panel.
- Install the electronic transmission range selector manual park release cable grommet nuts (1) and tighten to 6.5 N.m (58 lb in).
- Reposition the floor carpet and insulation.
- Install the electronic transmission range selector manual park release cable (2) to the front floor console support brace.
- Install the electronic transmission range selector manual park release cable handle bolt (1) and tighten to 2.5 N.m (22 lb in).
- Install the left front floor console extension panel. Front Floor Console Extension Panel Replacement - Left Side
- Connect the electronic transmission range selector manual park release cable (2).WARNING:
After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.
- Install the automatic transmission range selector lever bolt (1) and tighten to 9 N.m (80 lb in).
- Charge Air Cooler Inlet Air Tube (2) - Install
- Retainer Spring (1) - Engage
- Charge Air Cooler Inlet Air Tube (3) - Install
- Retainer Spring (2) - Engage
- Charge Air Cooler Inlet Air Tube Bolt (1) - Install and tighten 8.5 N.m (75 lb in)
- Engine Oil Cooler Coolant Outlet Hose (3) - Install - Engine Oil Cooler Coolant Outlet Hose Replacement (LSY)
- Engine Oil Cooler Hose Bolt (1) - Install and tighten [2x] 9 N.m (80 lb in)
- Evaporative Emission Hose (1) - Install - Evaporative Emission Hose Replacement
- Evaporative Emission Canister Purge Tube (1) - Install - Evaporative Emission Canister Purge Tube Replacement
CAUTION:
Refer to Fastener Caution .