Control Valve Solenoid Body Wiring Harness Removal

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts in the following chart represent components shown in graphic above.

Callout	Component Name
1	Control Valve Body Bolt [2x] or [3x] NOTE: Control valve body bolt quantity is wiring harness dependent.
2	Control Valve Solenoid Body Bolt
3	Automatic Transmission Wiring Harness Procedure Ensure you disconnect all the connectors from the valve body. On-Vehicle the Variable Feed Solenoid Clutch Accumulator Piston and Spring may fall out. Control Valve Body Assembly Disassemble (With ETRS) NOTE: The bolt retainer area on the wiring harness indicated by arrow may or may not be present. Newer design wiring harness does not have bolt retainer area.
4	Automatic Transmission Fluid Temperature Sensor Seal Procedure Remove and DISCARD the seal.