Circuit/System Verification

Verify the condition does not exist: Incorrect fluid level or condition - Refer to Transmission Fluid Level and Condition Check
- If a condition exists
  Repair or replace as necessary
- Go to next step: If no condition exists
Ignition - On / Vehicle - In Service Mode
Clear DTCs
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify DTC P18A8, P27EB, P27ED, P27EE, P27EF, P27F1, P27F2 is not set.
- If DTC P27EB, P27ED, P27EE, P27EF, P27F1, P27F2 is set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle
- If DTC P18A8 is set
  Refer to Diagnostic Fault Information
- Go to next step: If none of the DTCs are set
All OK.