Circuit/System Verification
- Ignition - On / Vehicle - In Service Mode
- Verify no other DTCs are set.
- If other DTCs are set
Refer to : Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step : If no other DTCs are set
- If other DTCs are set
- Replace the component : K111 Fuel Pump Driver Control Module
- Verify the DTC does not set.
- If the DTC is set
Replace the component : K20 Engine Control Module
- Go to next step : If the DTC is not set
- If the DTC is set
- All OK.