Circuit/System Verification
- Ignition - On / Vehicle - In Service Mode
- Verify the DTC P0461, P0462, P0463, or P0464 are not set
- If DTC P0461, P0462, P0463, or P0464 are set
Refer to Circuit/System Testing
- Go to next step : If DTC P0461, P0462, P0463, or P0464 are not set
- If DTC P0461, P0462, P0463, or P0464 are set
- If equipped, Perform the scan tool control function : Fuel Gauge Sweep
Verify the component activates : Fuel Gauge
- If the component does not activate
Test or replace the component : P16 Instrument Cluster
- Go to next step : If the component activates
- If the component does not activate
- Verify the scan tool parameter : Fuel Level Sensor = 0.5 to 3.5 V and changes & Varies with changes in fuel level.
- If not between 0.5 and 3.5 V or does not change
Refer to Circuit/System Testing.
- Go to next step : If between 0.5 and 3.5 V and changes
- If not between 0.5 and 3.5 V or does not change
- All OK.