LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2020 >> Terrain Denali, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Controls And Fuel - 1.5L (LYX) - Diagnostic Information And Procedures (2 Of 2)) >> Diagnostic Information and Procedures >> DTC P135A (Without NTM) >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition - On / Vehicle - In Service Mode
  2. Verify the scan tool parameter:Ignition Coil Supply Voltage=On
    • If not the specified state 

      Refer to: Circuit/System Testing

    • Go to next step: If the specified state 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 

      Refer to: Circuit/System Testing

    • Go to next step: If the DTC is not set 
  4. All OK.