Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition ON/Vehicle in Service Mode.
Verify that DTC P0641, P0651, P0697, or P06A3 is not set.
- If any of the DTCs are set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.
- Go to next step: If none of the DTCs are set
Verify that DTC P0182, P0183, P0187, P0188, P111F, P126E, P126F, P128A, or P128B are not set.
- If DTC P128A or P128B are the only DTCs set
  Test or replace the B310 Fuel Pressure/Temperature Sensor.
- If DTC P0183, P0184, P0187, P0188, P111F, P126E, P126F, P127C, P16E4, or P16E5 is set with any of the DTCs
  Refer to Circuit/System Testing.
- Go to next step: If none of the DTCs are set
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to Circuit/System Testing.
- Go to next step: If the DTC does not set
All OK.