Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition/Vehicle - Off
- Remove the appropriate component : T8 Ignition Coil - Leave the electrical connector connected.
- Install the special tool : J-26792 Ignition Spark Tester
- Engine - Running
- Verify there is spark at the tool.
- If there is no spark
Replace the component : T8 Ignition Coil
- Go to next step : If there is spark
- If there is no spark
- All OK.
NOTE:
Circuit/System Testing must be performed before proceeding with Component Testing.
NOTE:
An erratic or weak spark is considered a no spark condition.