Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Engine - Running
- Verify the scan tool parameter :
- Ignition Coil 1 - 4 Control Circuit High Voltage Test Status = OK or Not Run
- Ignition Coil 1 - 4 Control Circuit Low Voltage Test Status = OK or Not Run
- Ignition Coil 1 - 4 Control Circuit Open Test Status = OK or Not Run
- If not the specified state
Refer to : Circuit/System Testing
- Go to next step : If the specified state
- Verify the scan tool parameter :
- Ignition Coil 1 - 4 Control Circuit High Voltage Test Status = OK or Not Run
- Ignition Coil 1 - 4 Control Circuit Low Voltage Test Status = OK or Not Run
- Ignition Coil 1 - 4 Control Circuit Open Test Status = OK or Not Run
- Perform the action while monitoring the parameter :
- Wiggle the harness and connector : T8 Ignition Coil
- Wiggle the harness and connector : K20 Engine Control Module
- If not the specified state
Repair as necessary - Wiring / Terminal(s) / Electrical Connector(s)
- Go to next step : If the specified state
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to : Circuit/System Testing
- Go to next step : If the DTC is not set
- If the DTC sets
- All OK.