Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition/Vehicle - Off
- Disconnect the electrical connector : B34 Engine Coolant Temperature Sensor
- Test the resistance between the test points : Signal circuit terminal 2 & Low Reference circuit terminal 1
- Verify the value is within the range listed in the table : Temperature Versus Resistance - Engine Coolant Temperature Sensor
- If not in the specified range
Replace the component : B34 Engine Coolant Temperature Sensor
- Go to next step : If in the specified range
- If not in the specified range
- Test for infinite resistance between the test points : Each terminal of the component & The component's housing
- If less than infinite resistance
Replace the component : B34 Engine Coolant Temperature Sensor
- Go to next step : If infinite resistance
- If less than infinite resistance
- All OK.