Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Verify the condition does not exist : Incorrect fluid level or condition - Refer to : Loss of Coolant
- If a condition exists
Repair or replace as necessary.
- Go to next step : If no condition exists
- If a condition exists
- Verify there are no DTCs set related to the following component/system : B34 Engine Coolant Temperature Sensor
- If a related DTC is set
Refer to : Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step : If a related DTC is not set
- If a related DTC is set
- Engine - Running @ 1, 800 to 2, 200 RPM
Verify the scan tool parameter : ECT Sensor = Greater than 80°C (176°F) - Within 15 min
- If 80°C (176°F) or colder
Test or replace the component : Engine Coolant Thermostat
- Go to next step : If warmer than 80°C (176°F)
- If 80°C (176°F) or colder
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to : Circuit/System Testing
- Go to next step : If the DTC does not set
- If the DTC sets
- All OK.