Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition/Vehicle - Off
- Disconnect the electrical connector : B75C Multifunction Intake Air Sensor
- Test for 49 to 49, 882 ohms between the test points : Signal terminal 1 & Low Reference terminal 3
- If not between 49 and 49, 882 ohms
Replace the component : B75C Multifunction Intake Air Sensor
- Go to next step : If between 49 and 49, 882 ohms
- If not between 49 and 49, 882 ohms
- Verify the value is within the range listed in the table : Temperature Versus Resistance - Intake Air Temperature Sensor
- If not in the specified range
Replace the component : B75C Multifunction Intake Air Sensor
- Go to next step : If in the specified range
- If not in the specified range
- Test for infinite resistance between the test points : Each terminal of the component & The component's housing
- If less than infinite resistance
Replace the component : B75C Multifunction Intake Air Sensor
- Go to next step : If infinite resistance
- If less than infinite resistance
- All OK.