Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On / Vehicle - In Service Mode
- Verify DTC P0106, P0107, P0108, P2122, P2123, P2127, P2128, P2138, P2610 is not set.
- If any of the DTCs are set
Refer to : Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step : If none of the DTCs are set
- If any of the DTCs are set
- Verify the scan tool parameter :
- BARO Sensor = Altitude Versus Barometric Pressure - The value should be within the range listed in the table.
- MAP Sensor = Altitude Versus Barometric Pressure - The value should be within the range listed in the table.
- Turbocharger Boost Sensor = Altitude Versus Barometric Pressure - The value should be within the range listed in the table.
- If not in the specified range
- {BARO Sensor}Refer to : DTC P2227-P2230
- {MAP Sensor}Refer to : DTC P0106, P0107, or P0108
- {Turbocharger Boost Sensor}Refer to : DTC P0236, P0237, or P0238
- Go to next step : If in the specified range
- All OK.