Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On / Vehicle - In Service Mode
- Verify DTC P00F4, P00F5, P00F6, P0102, P0103, P0641, P0651, P0697, P06A3, P06D2 is not set.
- If any of the DTCs are set
Refer to : Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step : If none of the DTCs are set
- If any of the DTCs are set
- Engine - Running
- Verify the scan tool parameter : Intake Air Humidity Sensor = 5 to 90%
- If not between 5 and 90%
Refer to : Circuit/System Testing
- Go to next step : If between 5 and 90%
- If not between 5 and 90%
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to : Circuit/System Testing
- Go to next step : If the DTC is not set
- If the DTC sets
- All OK.