Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Timing Chain Tensioner Shoe(2) - Install

CAUTION:

Refer to Fastener Caution .

Timing Chain Tensioner Shoe Bolt(1) - Install and tighten25 N.m (18 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Install a NEW gasket.(2)
Timing Chain Tensioner(1) - Install
Timing Chain Tensioner Bolt(4) - Install and tighten25 N.m (18 lb ft) [2x].
Remove the suitable tool (3) from the timing chain tensioner.
Courtesy of GENERAL MOTORS COMPANY

Remove the EN-51367 holder (1).
Timing Chain Upper Guide - Install - Timing Chain Upper Guide Replacement

Check the position of the crankshaft, camshaft and camshaft position actuator adjuster.

TEMPORARILY install the engine front cover with 4 bolts and the crankshaft balancer.

GM3682494

Courtesy of GENERAL MOTORS COMPANY

Turn crankshaft 720 degrees in the direction of engine rotation by the crankshaft balancer bolt (3).

Courtesy of GENERAL MOTORS COMPANY

NOTE:
If the EN-51367 holder (1) can be installed, the engine timing is properly adjusted. If the EN-51367 holder (1) can not be installed, confirm the engine is set to cylinder 1 top dead center (TDC) of combustion stroke.

Install the EN-51367 holder (1).
Remove the EN-51367 holder.
Remove the TEMPORARILY installed engine front cover and crankshaft balancer.
Engine Front Cover - Install - Engine Front Cover Replacement

NOTE:

Right Side

Front Wheelhouse Liner-Right Side - Install - Front Wheelhouse Liner Replacement - Right Side (Equinox)Front Wheelhouse Liner Replacement - Right Side (Terrain)
Camshaft Cover - Install - Camshaft Cover Replacement