Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Install NEW oil pump seals (1).
Tilt the oil pump assembly (1) in order to install the drive chain over the oil pump shaft sprocket.
- CAUTION:
Refer to Fastener Caution .
NOTE:Ensure the oil pump assembly (2) is properly positioned. The fasteners should only be installed and tightened after the drive chain is correctly positioned on the sprocket.
Install the oil pump fasteners (1). Tighten to 10 N.m (89 lb in)
- If replacing the oil pump, install the oil pump flow control solenoid valve. Oil Pump Flow Control Solenoid Valve Replacement
Remove the suitable tool (2) to unlock the tensioner (1).
- Upper Oil Pan Replacement - Install