Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Camshaft Position Actuator - Remove - Camshaft Position Actuator Replacement
- NOTE:
Many internal engine components will develop specific wear patterns on their friction surfaces. Components MUST be separated, marked, or organized in a way to ensure installation to their original location and position. Take precautions in order to prevent interchanging of parts.
Tag or mark each part immediately after removal. Indicate location, direction, and orientation when necessary.
- Loosen the 12 camshaft bearing cap bolts (1) 1/2 turn working from outside to inside in a spiral in direction.
- Remove the camshaft bearing cap bolts.(1)[12x]
- Remove the camshaft bearing caps.(2)[6x]
- Remove the exhaust camshaft.(3)
NOTE:
Observe the markings on the bearing caps. Ensure that each bearing cap is marked in order to identify its location and direction.