Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Engine Oil Level Indicator Control Module Wiring Harness(2) - Install
- Wiring Harness Connector Bolt(1) - Install and tighten10 N.m (89 lb in)
{ If equipped } Wiring Harness Retainer(2) - Install [2x]
- Electrical Connector(1)@Oil Pump Flow Control Solenoid Valve(1) - Connect
Electrical Connector(1)@Engine Oil Level Indicator Control Module Wiring Harness - Connect
- Lower Oil Pan - Install - Lower Oil Pan Replacement (AWD) Lower Oil Pan Replacement (FWD)
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (KL9)
CAUTION: