LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2020 >> Terrain Denali, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 1.5L (LYX)) >> Repair Instructions >> Crankshaft Balancer Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Drive Belt - Remove - Drive Belt Replacement 
  2. GM3686986Courtesy of GENERAL MOTORS COMPANY

    Install the EN-44226-1  remover (2) to the crankshaft balancer (1).

  3. Loosen the crankshaft balancer bolt (4) by counter holding the crankshaft balancer (1) with the EN-44226-1  remover (3).
  4. Remove the EN-44226-1  remover (3).
  5. Remove the crankshaft balancer bolt (4).
  6. GM3686991Courtesy of GENERAL MOTORS COMPANY

    Install the EN-44226-5  protector (1) to the crankshaft (2).

  7. GM3952844Courtesy of GENERAL MOTORS COMPANY

    Install EN-44226-1  remover (2) and EN-44226-2  remover plate (3) onto the balancer (4).

  8. Install the EN-44226-3  remover screw (1) through the EN-44226-2  remover plate and against the EN-44226-5  protector.
  9. Counter hold the EN-44226-1  remover (2) and turn the EN-44226-3  remover screw to remove the balancer(4).
  10. Remove the EN-44226  remover.
  11. Remove the crankshaft balancer (4).
  12. Remove the EN-44226-5  protector.
scientia non olet · About LEMON Manuals