Crankshaft Balancer Removal

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Install the EN-51760 holder, lock the automatic transmission flex plate via the starter ring gear. Special Tools EN-51760 Flywheel HolderFor equivalent regional tools, refer to Special Tools .
1	Crankshaft Balancer Bolt
2	Crankshaft Balancer Procedure Install the EN-44226-5 protector onto the crankshaft. Install EN-44226-1 holding body and EN-44226-2 remover plate with remover bolt onto the balancer. Counter hold the EN-44226-2 remover plate and turn the remover screw to remove the balancer. Special Tools EN-44226 Crankshaft Balancer Remover EN-44226-5 Crankshaft Protector

Callout

Component Name

Preliminary Procedure

Install the EN-51760 holder, lock the automatic transmission flex plate via the starter ring gear.

Special Tools EN-51760 Flywheel HolderFor equivalent regional tools, refer to Special Tools .

Crankshaft Balancer Bolt

Crankshaft Balancer

Procedure

Install the EN-44226-5 protector onto the crankshaft.
Install EN-44226-1 holding body and EN-44226-2 remover plate with remover bolt onto the balancer.
Counter hold the EN-44226-2 remover plate and turn the remover screw to remove the balancer.

Special Tools