Installation Procedure

WARNING: This page is about a different variant/trim than selected.

NOTE:

Install NEW bolts.

NOTE:

Bolts have adhesive patch and must be tightened to final torque within 5 minutes.

Automatic Transmission Flex Plate Bolt(1) - Loosely install[8x]
Fig 1: Flywheel Bolts Tightening Sequence
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

CAUTION:
Refer to Torque-to-Yield Fastener Caution .

Tighten the flywheel bolts in the sequence shown.

Tighten
1. First Pass:20 N.m (15 lb ft)
2. Second Pass:30 N.m (22 lb ft)
3. Final Pass:70 degrees, using the EN-45059 angle meter
Remove the EN-51760 Holding tool.
Transmission - Install - Transmission Replacement (FWD)Transmission Replacement (AWD)