Throttle Body Inspection and Cleaning
WARNING: This page is about a different variant/trim than selected.
- Throttle Body Assembly Replacement - Remove
- Inspect the throttle body bore and the throttle valve plate for deposits.
- Clean the throttle body bore and the throttle valve plate using a clean shop towel with an appropriate cleaner.
- Throttle Body Assembly Replacement - Install.
- Perform the following procedure/test:Diagnostic Repair Verification
- Perform the following learn procedure:Throttle Body Idle Air Flow Compensation Reset
WARNING:
Turn OFF the ignition before inserting fingers into the throttle bore. Unexpected movement of the throttle blade could cause personal injury.
CAUTION:
Do not insert any tools into the throttle body bore in order to avoid damage to the throttle valve plate.
NOTE:
Fully open the throttle valve in order to inspect the throttle body bore and the throttle valve plate for any deposits.
CAUTION:
Do not use any solvent that contains Methyl Ethyl Ketone (MEK). This solvent may damage fuel system components.