Removal Procedure
WARNING: This page is about a different car, the 2020 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
- Set the parking brake and chock the wheels.
- Perform the Backup Park Lock Actuator Disarming procedure. Backup Park Lock Actuator Disarming (with MHG)
- Remove the charge air cooler outlet air tube. Charge Air Cooler Outlet Air Tube Replacement
- Remove the primary brake pressure modulator valve pipe. Brake Pressure Modulator Valve Pipe Replacement (Primary) , or Brake Pressure Modulator Valve Pipe Replacement (Secondary)
- Remove the secondary brake pressure modulator valve pipe. Brake Pressure Modulator Valve Pipe Replacement (Primary) , or Brake Pressure Modulator Valve Pipe Replacement (Secondary)
Remove the brake master cylinder (1). Brake Master Cylinder Replacement
Remove the heater inlet and outlet pipe bracket nut (1).
- Reposition the radiator surge tank out of the way. Radiator Surge Tank Replacement (LYX without KL9) , or Radiator Surge Tank Replacement (LTG LYX with KL9)
- Disconnect the three starter cable retainers from the range selector actuator.
- Disconnect the electrical connector.
- Disconnect the range selector actuator lever link.
Remove the three range selector actuator retaining fasteners (1).
- Remove the range selector actuator (2).
- Transfer components as necessary.
NOTE:
If re-installing the original automatic transmission range selector actuator hardware module back into the vehicle, the Backup Park Lock Actuator must be activated prior to removal.
NOTE:
If the automatic transmission range selector actuator hardware module is being replaced due to a malfunction, the original module does not need to be activated prior to removal.
NOTE:
Perform this procedure before disconnecting the battery and removal of the actuator.