Circuit/System Verification
WARNING: This page is about a different car, the 2020 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode
- Verify there are no DTCs set related to the following component/system : Serial Data
- If a related DTC is set
Refer to : Diagnostic Trouble Code (DTC) List - Vehicle
- If a related DTC is not set
- Ignition/Vehicle - Off
- Replace the component : Q8 Control Solenoid Valve Assembly
- Operate the vehicle within the Conditions for Running the DTC.
- Verify the DTC does not set.
- If the DTC sets - Replace the component : K20 Engine Control Module
- Go to next step : If the DTC is not set
- All OK.
- Go to next step : If no DTC is set
- If a related DTC is set
- All OK.