LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2020 >> Terrain Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Automatic Transmission - 6T40 (MNH) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P2728-P2730 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2020 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On / Vehicle - In Service Mode
  2. Perform the scan tool control function : Pressure Control Solenoid Valve 5 - On and Off

    Verify the scan tool parameter :

    • Pressure Control Solenoid Valve 5 Control Circuit High Voltage Test Status = OK or Not Run
    • Pressure Control Solenoid Valve 5 Control Circuit Low Voltage Test Status = OK or Not Run
    • Pressure Control Solenoid Valve 5 Control Circuit Open Test Status = OK or Not Run
    • If not the specified state 

      Refer to : Component Testing

    • Go to next step : If the specified state 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 

      Refer to : Component Testing

    • Go to next step : If the DTC is not set 
  4. All OK.
scientia non olet · About LEMON Manuals