Circuit/System Verification
WARNING: This page is about a different car, the 2020 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode
- Perform the following action : Range Selector Lever Cable Adjustment
- Operate the component : S3 Transmission Shift Lever - Select each position
Verify the scan tool parameter : Internal Mode Switch A/B/C/P @ Transmission Control Module = The switch states match the values given in the table. - Refer to : Transmission Internal Mode Switch Logic
- If not the specified state
Refer to : Circuit/System Testing
- Go to next step : If the specified state
- If not the specified state
- Operate the component : S3 Transmission Shift Lever - Select each position
- { R, D, M }Verify the scan tool parameter : Park/Neutral Position Switch @ Engine Control Module = In Gear
- { P, N } Verify the scan tool parameter : Park/Neutral Position Switch @ Engine Control Module = Park/Neutral
- If not the specified state
Refer to : Circuit/System Testing
- Go to next step : If the specified state
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to : Circuit/System Testing
- Go to next step : If the DTC is not set
- If the DTC sets
- All OK.