Installation Procedure
- Install the master cylinder secondary brake pipe to the vehicle.
Install the retainers (1) for the body harness.
Remove plug from the BPMV inlet port.
- Install the master cylinder secondary brake pipe fitting (1) to the BPMV. Brake Pressure Modulator Valve Replacement
Install the master cylinder secondary brake pipe to the top frame rail retaining clip (1).
- Reposition the vehicle body to the frame and install the cushions. Body Mount Upper and Lower Cushion Replacement (Long Wheel Base) , or Body Mount Upper and Lower Cushion Replacement (Short Wheel Base)
- {If equipped} Install evaporative emission rear pipe.
- For LCV engines, refer to Evaporative Emission Rear Pipe Replacement .
- For LGZ engines, refer to Evaporative Emission Rear Pipe Replacement .
- Install fuel feed rear pipe.
- For LCV engines, refer to Fuel Feed Rear Pipe Replacement .
- For LWN engines, refer to Fuel Feed Rear Pipe Replacement , or Fuel Feed Front Pipe Replacement .
- For LGZ engines, refer to Fuel Feed Rear Pipe Replacement .
Install the master cylinder secondary brake pipe to the left frame rail retaining clips (1).
Install the master cylinder secondary brake pipe to the retaining clips (1, 2).
- Connect left front wheel speed sensor harness connector. Front Wheel Speed Sensor Replacement (Without ZR2) , or Front Wheel Speed Sensor Replacement (With ZR2)
- Install the left front wheelhouse liner. Front Wheelhouse Liner Replacement (Without ZR2) , or Front Wheelhouse Liner Replacement (With ZR2) , or Front Wheelhouse Liner Replacement (Bison)
- Install the intermediate steering shaft at lower steering shaft. Intermediate Steering Shaft Replacement
Remove the plugs from the master cylinder outlet port.
- Install the master cylinder secondary brake pipe fitting (1). Brake Master Cylinder Replacement
- Bleed the hydraulic brake system. Hydraulic Brake System Bleeding (Manual) , or Hydraulic Brake System Bleeding (Pressure)