LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2020 >> Acadia SL >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 9T50 (M3H), 9T60 (M3G) Or 9T65 (M3W M3V) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Transmission Mount Strut Replacement (Front Wheel Drive) >> Installation Procedure

Installation Procedure

  1. Using the outline made by the spray paint or marker, position the transmission mount to the drivetrain and front suspension cradle.
  2. GM4729017Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    CAUTION:

    Refer to TORQUE-TO-YIELD FASTENER CAUTION .

    Install the NEW transmission rear mount bolts (2) and nuts and tighten the bolts to 100 N.m (74 lb ft) plus 95 to 105 degrees.

  3. Install the transmission mount to bracket through bolt (1) and tighten to 100 N.m (74 lb ft).
  4. Remove the jack stand.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals