Component Testing

Static Test

1. Ignition/Vehicle - Off
2. Remove the component : Control Valve Body Cover
3. Disconnect the electrical connector : M123 Transmission Park Valve Lock Solenoid Actuator
4. Test for 15 to 25 ohms between the test points : Control terminal 1 & Control terminal 2
   • If not between 15 and 25 ohms 

     Replace the component : M123 Transmission Park Valve Lock Solenoid Actuator

   • Go to next step : If between 15 and 25 ohms 
5. Test for infinite resistance between the test points : Each terminal of the component & The component's housing
   • If less than infinite resistance 

     Replace the component : M123 Transmission Park Valve Lock Solenoid Actuator

   • Go to next step : If infinite resistance 
6. All OK.