Circuit/System Verification

Ignition - On / Vehicle - In Service Mode
Verify there are no DTCs set related to the following component/system : LIN Bus
- If a related DTC is set
  Refer to : Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step : If a related DTC is not set
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to Circuit/System Testing.
- Go to next step : If the DTC does not set
All OK.