LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2020 >> Acadia SL >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 9T50 (M3H), 9T60 (M3G) Or 9T65 (M3W M3V) - Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> DTC P0815, P0816, or P0826 >> Component Testing

Component Testing

  1. Ignition/Vehicle - Off
  2. Remove the component : Transmission Control Lever Knob
  3. Disconnect the electrical connector : S3 Transmission Shift Lever
  4. Test for 5, 900 to 6, 400 ohms between the test points : Signal terminal 3 & Ground circuit terminal 2
    • If not between 5, 900 and 6, 400 ohms 

      Replace the component : S2A Transmission Manual Shift Switch - Up/Down

    • Go to next step : If between 5, 900 and 6, 400 ohms 
  5. Press and hold the switch : S2A Transmission Manual Shift Switch - Up/Down - Downshift
  6. Test for 1, 900 to 2, 100 kohms between the test points : Signal terminal 3 & Ground circuit terminal 2
    • If not between 1, 900 and 2, 100 ohms 

      Replace the component : S2A Transmission Manual Shift Switch - Up/Down

    • Go to next step : If between 1, 900 and 2, 100 ohms 
  7. Press and hold the switch : S2A Transmission Manual Shift Switch - Up/Down - Upshift
  8. Test for 600 to 660 ohms between the test points : Signal terminal 3 & Ground circuit terminal 2
    • If not between 600 and 660 ohms 

      Replace the component : S2A Transmission Manual Shift Switch - Up/Down

    • Go to next step : If not between 600 and 660 ohms 
  9. Test for infinite resistance between the test points : Each terminal of the component & The component's housing
    • If less than infinite resistance 

      Replace the component : S2A Transmission Manual Shift Switch - Up/Down

    • Go to next step : If infinite resistance 
  10. All OK.
scientia non olet · About LEMON Manuals