LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2020 >> Acadia SL >> Repair and Diagnosis >> External Pages >> Different car >> Section 457 (Automatic Transmission - 9T60 (M3G) Or 9T65 (M3W) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Control Valve Body Cover Installation >> Single Use Fasteners and Components

Single Use Fasteners and Components

WARNING: This page is about a different car, the 2023 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Control Valve Body Cover Bolts Tightening Sequence
GM4376124Courtesy of GENERAL MOTORS COMPANY
NOTE: Callouts items in the following chart represent components shown in graphic above.
Callout Component Name
1 Body Side Wiring Harness Opening Seal
Procedure 
Install a NEW seal. Do NOT reuse the old seal.
2 Control Valve Body Cover Gasket
Procedure 
Install a NEW gasket. Do NOT reuse the old gasket.
3 Control Valve Body Cover
4 Control Valve Body Cover Bolt [6x]
CAUTION:

Refer to Fastener Caution .


Tighten in sequence 
11 N.m (8 lb ft)
5 Control Valve Body Cover Stud [6x]
Tighten in sequence 
11 N.m (8 lb ft)