LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2020 >> Acadia SL >> Repair and Diagnosis >> External Pages >> Different car >> Section 457 (Automatic Transmission - 9T60 (M3G) Or 9T65 (M3W) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Control Valve Body Cleaning and Inspection (With ETRS) >> Control Valve Body (2 of 2)

Control Valve Body (2 of 2)

WARNING: This page is about a different car, the 2023 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
GM4572665Courtesy of GENERAL MOTORS COMPANY
NOTE: Callouts items in the following chart represent components shown in graphic above.
Control Valve Body (2 of 2)

Callout Component Name
WARNING:

Valve springs can be tightly compressed. Use care when removing retainers and plugs. Personal injury could result.

CAUTION:

After cleaning the transmission components, allow to air dry. Do not use cloth or paper towels in order to dry any transmission components. Lint from the towels can cause component failure.

CAUTION:

Do not reuse cleaning solvents. Previously used solvents may deposit sediment which may damage the component.

Preliminary Procedure Clean and inspect all valve components and the valve body. The control valve body assembly is only replaceable as an assembly.
1 Automatic Transmission Fluid Level Control Valve
2 Automatic Transmission Fluid Level Control Valve Spring
3 Oil Level Control Valve Spring Retainer
4 Feed Limit Valve
5 Feed Limit Valve Spring
6 Feed Limit Valve Spring Retainer
7 4th Clutch Regulator Valve Bore Plug Retainer
8 4th Clutch Regulator Valve Bore Plug
9 4th Clutch Regulator Valve
10 3-8 Clutch Regulator Valve Spring
11 3-8 Clutch Regulator Valve Spring
12 3-8 Clutch Regulator Valve
13 3-8 Clutch Regulator Valve Bore Plug
14 3-8 Clutch Regulator Valve Bore Plug Retainer
15 Actuator Feed Limit Valve Spring Retainer
16 Actuator Feed Limit Valve Spring
17 Actuator Feed Limit Valve
18 Mode Valve Position Switch Magnet [2x]