Installation Procedure
Brake Master Cylinder Bracket (2) - Install NEW
- Brake Master Cylinder Bracket Bolt (1) - Install and tighten [2x] - Brake and Accelerator Pedal Assembly Replacement (GMC without JEO) , or Brake and Accelerator Pedal Assembly Replacement (with JEO)
Brake PedalRetainer (1) - Install NEW
Brake Master Cylinder (1) - Install
- NOTE:
Some components not shown for graphic clarity.
CAUTION:Brake Master Cylinder Bracket Nut (1) - Install and tighten [2x] 22 N.m (16 lb ft)
Wiring Harness Clip (1) - Secure
Brake Master Cylinder Bracket Nut (2) - Install and tighten 22 N.m (16 lb ft)
- Connect the electrical connector. (1)
- Remove the plugs from the brake master cylinder ports and the brake pipes.
Brake Pipe Fitting (2) - Install and tighten [4x] 18 N.m (13 lb ft)
- Connect the electrical connector. (1)
Turbocharger Outlet Duct Connector (1) - Remove - Turbocharger Outlet Duct Connector Replacement
Air Cleaner Outlet Intermediate Duct (1) - Remove - Air Cleaner Outlet Intermediate Duct Replacement
- Radiator Surge Tank - Install - Radiator Surge Tank Replacement (LCV) , or Radiator Surge Tank Replacement (LGX without C69) , or Radiator Surge Tank Replacement (LSY) , or Radiator Surge Tank Replacement (LGX with C69)
Brake PedalRetainer (1) & Brake Pedal (2) @Power Brake Booster Pushrod - Secure
- Floor Front Air Outlet Duct - Left Side - Install - Floor Front Air Outlet Duct Replacement - Left Side (LHD)
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Perform the necessary programming and setup procedure: Control Module References
- Bleed the brake system. Hydraulic Brake System Bleeding (Manual without JEO) , or Hydraulic Brake System Bleeding (Pressure without JEO) , or Hydraulic Brake System Bleeding (Pressure with JEO)
- Fill the brake master cylinder reservoir to the maximum-full level with GM approved brake fluid from a clean, sealed brake fluid container. Brake Master Cylinder Reservoir Filling
- Check for brake system leaks.
Refer to the procedure link for torque specification.