LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2020 >> Acadia SL >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Diagnostic Information and Procedures >> DTC P25C6 or P25C7 >> Circuit/System Verification

Circuit/System Verification

  1. Ignition - On / Vehicle - In Service Mode
  2. Verify DTC is not set:
    • If the DTC is set 
    1. Perform all necessary programming and setup procedures for the control module: K160 Brake System Control Module
    2. Verify the DTC does not set.
      • If the DTC sets - Replace the component: K160 Brake System Control Module
      • Go to next step: If the DTC is not set
    3. All OK.
    • Go to next step: If the DTC is not set 
  3. All OK.
scientia non olet · About LEMON Manuals